1: \subsection{Statistical analysis of intensity distribution}

2: \label{sec:stati}

3: By the methods presented in the previous sections (\ref{sec:QyProj}

4: and \ref{sec:SinglePeakAna}) information can be gathered on the

5: overall strain distribution in the illuminated grain, and on the

6: strain in the individual scattering entities giving rise to the peaks.

7: Information on the strain distribution in the material which gives the

8: cloud is a very good complement to these data on the grain and

9: the subgrains.

10: 

11: The problem with gathering information on the cloud is that it is very

12: hard to locate parts of the cloud which have no influence from the

13: superimposed peaks. A statistical method for analyzing the overall

14: distribution of strains in the illuminated material has been devised

15: to overcome this problem.

16: 

17: The algorithm of the technique is as follows (see also figure

18: \ref{fig:StatisticalAnalysis}):

19: \begin{itemize}

20: \item All possible radial\footnote{To simplify the procedure the line

21:     profiles are gathered along detector pixel columns, which are all

22:     very close to the radial direction.} line profiles are gathered

23:   (that is, one for each pixel/bin in the azimuthal plane).

24: \item For each profile the maximum intensity, $I_{\text{max}}$, is found.

25: \item The $\ve  q_y$-position of this maximum, $q_{y,\text{max}}$, is found.

26: \item The $(q_{y,\text{max}},I_{\text{max}})$ pairs are binned into

27:   log-intensity bins of constant width.

28: \item The mean $q_{y,\text{max}}$ value is finally calculated for each bin,

29:   together with the number of points in each bin.

30: \end{itemize}

31: 

32: 

33: \begin{figure}

34:   \centering

35:   \begin{minipage}{0.65\linewidth}

36:   \includegraphics[width=\textwidth]{AnalysisMethods/figs/statistical_part1.eps}      \end{minipage}

37: \begin{minipage}{0.3\linewidth}

38:   \vspace{2.5mm}

39:   \includegraphics[angle=90,height=2.57cm]{AnalysisMethods/figs/statistical_part2.eps} 

40: \end{minipage}

41: \caption{Ilustration of the statistical analysis method. The left part

42:   shows a raw detector image. The right part is the intensity profile

43:   along the red line indicated on the raw detector image. $I_{max}$

44:   and $q_{y,max}$ are indicated on the plot.}

45:   \label{fig:StatisticalAnalysis}

46: \end{figure}

47: 

48: An overview of the strain distribution is gathered by plotting the

49: mean $q_{y,\text{max}}$ as a function of intensity (an example of such

50: a plot is given in figure \ref{fig:StatisticalWall}).  The points at low

51: intensity will correspond to an average over mainly the cloud, as the

52: cloud has a much lower intensity than the peaks. In this way

53: information on the average strain in the material giving the cloud can

54: be obtained.

55: 

56: 

57: