1: \begin{abstract}

2: Burn  efficiency $\Phi$ is a key for  commercial feasibility of fusion power station for inertial fusion energy, while $\Phi$ is usually  lower than  30$\%$  in the central ignition scheme of inertial confinement fusion (ICF).

3: A recent conceptual design for a  10 MJ laser driver [Z. Sui and K. Lan et al., {\it Matter Radiat. Extremes} {\bf 9}, 043002 (2024)] provides a new room for  target design to achieve a higher $\Phi$.

4: Here, we take the advantage of fuel density in reaction rate and propose a novel amplifier scheme for increasing $\Phi$   via two cascading explosions by ICF.

5: The amplifier scheme can be realized either by indirect-drive or by direct-drive.

6: Here, we give a 1D design for an indirect-driven amplifier capsule  containing 2.02 mg DT fuel under a 300 eV radiation generated by a 10 MJ and 1785 TW laser inside an octahedral spherical hohlraum.

7: At stagnation, it forms an extremely dense shell surrounding central hot fuel,  with a  density ratio of shell to central  $>$ 20.

8: About 53 ps after stagnation, benefiting from the extremely high density of the shell and the deposition of $\alpha$ particles generated in the central hot fuel, the primary explosion happens in the shell.

9: Then, the  primary explosion in shell drives the central fuel to converge spherically towards the center.

10: At about 18 ps after the primary explosion, the central fuel converges at  center with

11: 1100 g/cm$^3$,  770 keV and 320 Tbar, leading to the secondary explosion inside this extremely hot and dense fireball.

12: %We also simulated the NIC-Rev5 CH capsule in central ignition scheme for comparison.

13: As a result, the  amplifier capsule has $\Phi$ = 48$\%$ and G = 33 at convergence ratio $C_r$ = 24. This novel scheme can achieve a relatively high burn efficiency at a relatively low $C_r$, which can greatly relax the stringent  requirements of high gain fusion on  hot spot ignition conditions and engineering issues.

14: \end{abstract}