1: \begin{abstract}

2: Shape optimization is a challenging task in many engineering fields,

3: since the numerical solutions of parametric system may be

4: computationally expensive. This work presents a novel optimization

5: procedure based on reduced order modeling, applied to a naval hull

6: design problem. The advantage introduced by this method is that the

7: solution for a specific parameter can be expressed as the combination

8: of few numerical solutions computed at properly chosen parametric

9: points. The reduced model is built using the proper orthogonal

10: decomposition with interpolation (PODI) method.

11: We use the free form deformation (FFD) for an automated perturbation

12: of the shape, and the finite volume method to simulate the multiphase

13: incompressible flow around the deformed hulls. Further computational

14: reduction is done by the dynamic mode decomposition (DMD) technique:

15: from few high dimensional snapshots, the system evolution is

16: reconstructed and the final state of the simulation is faithfully

17: approximated. Finally the global optimization algorithm iterates over

18: the reduced space: the approximated drag and lift coefficients are

19: projected to the hull surface, hence the resistance is evaluated for

20: the new hulls until the convergence to the optimal shape is achieved.

21: We will present the results obtained applying the described procedure

22: to a typical Fincantieri cruise ship.

23: \end{abstract}

24: