1: \begin{figure}[b]
2: \centering
3: \includegraphics[width=78mm]{detectorlayout.eps}
4: \caption{BTeV pixel detector layout.}
5: \label{fig:detectorlayout}
6: \end{figure}
7:
8: BTeV is a proposed particle accelerator-based High Energy Physics (HEP) experiment currently under development at Fermi National Accelerator Laboratory. The goal is to study charge-parity violation, mixing, and rare decays of particles known as beauty and charm hadrons, in order to learn more about matter-antimatter asymmetries that exist in the universe today \cite{sk:pixeldetect02}. When approved, the BTeV experiment will be sponsored by the Department of Energy.
9:
10: The BTeV experiment will operate in conjunction with a particle accelerator where the collision of protons with anti-protons can be recorded and examined for detached secondary vertices from charm and beauty hadron decays \cite{eg:detachedtrigger00}. The layout for the BTeV detector is shown in Figure \ref{fig:detectorlayout}.
11:
12: The experiment uses approximately 30 planar silicon pixel detectors to record interactions between colliding protons and antiprotons in the presence of a large magnetic field. The pixel detectors, along with readout sensors are embedded in the accelerator, which are connected to specialized field-programmable gate arrays (FPGAs). The FPGAs are connected to approximately 2,500 digital signal processors (DSPs).
13:
14: The measurements of the interactions resulting from the collision of protons and antiprotons are carried via custom circuitry hardware to localized processors that reconstruct the 3-dimensional crossing data from the silicon detector in order to examine the trajectories for detached secondary vertices \cite{sn:vandy03}. These detached vertices are indicators of the likely presence of beauty or charm decays.
15:
16: BTeV will operate at a luminosity of 2x10$^{32}$cm$^{-2}$s$^{-1}$ corresponding to about 6 interactions per 2.53 MHz beam crossing rate \cite{sk:pixeldetect02}. Average event sizes will be around 200 Kilobytes after zero-suppression of data is performed on-the-fly by front-end detector electronics. Every beam crossing will be processed, which translates into the extremely high data rate of approximately 1.5 Terabytes of data every second, from a total of 20x10$^{6}$ data channels.
17:
18: A three tier hierarchical trigger architecture will be used to handle this high rate. Data from the pixel detector and muon detector will be sent to the Level 1 trigger processors, where an accept or reject decision will be made for every crossing. The Level 1 vertex trigger processor will perform pattern recognition, track, and vertex reconstruction on the pixel data for every interaction \cite{sk:pixeldetect02}. It has been estimated that 99\% of all minimum-bias events will be rejected by the Level 1 vertex trigger, while 60-70\% of the events containing beauty or charm decay will still be accepted for further evaluation.
19:
20: Levels 2 and 3 will be implemented on a cluster, and data that makes it past the Level 1 filter is assigned to one of these Level 2/3 processors for further analysis. Data that survives Level 2 will be passed to Level 3 algorithms to determine whether or not it should be recorded on archival media \cite{jb:ftissues02}.
21:
22:
23: It is estimated that Level 2 will decrease the data rate by a factor of 10, and Level 3 will further reduce the incoming rate by a factor of 2. Once data is filtered through all three levels, and additional data compression is performed, it is expected that the resulting data rate will be approximately 200 Megabytes per second.
24: