1: \subsection{Particle Identification}\label{section_pid}

2: 

3: For many of the e89-008 kinematics, there was a large pion background, 

4: sometimes up to 100 times the electron rate.  Loose cuts on the gas

5: \v{C}erenkov detector and lead-glass shower counter were used to reject pions

6: in the trigger, and tighter cuts were applied in the offline analysis.

7: The cuts used and their efficiency are discussed in section 

8: \ref{subsec_pidcuts}.

9: 

10: The \v{C}erenkov consisted of four mirrors and PMTs in the SOS, and two in 

11: the HMS.  In both cases, the Analog-to-Digital Converter (ADC) output from

12: each PMT was converted into the number of detected photoelectrons.  The

13: \v{C}erenkov signal for the event is just the sum of the signals from the

14: phototubes.  No corrections were applied for position dependence of the

15: signal, but the cuts were chosen to give high efficiency over the entire

16: acceptance of the spectrometer.

17: 

18: For the calorimeter, one ADC value is measured for each module.  The ADC value

19: is converted to energy deposited in the block in GeV. Clusters of hits are

20: located, and the energy per layer and total energy is calculated for each

21: cluster.  For each track found by the drift chambers, the energy associated

22: with that track is the energy of the cluster that the track points to, if

23: there is one.  The energy is corrected for attenuation in the blocks based on

24: the distance of the hit from the PMT, as determined by the tracking.

25: